Tuesday, November 22, 2011

How To Enable The Use of Third-Party GBICs and SFPs on Cisco Switches

Enable the command below. Please note that the following Cisco warning message will be auto-displayed when this command is enabled.

Switch(config)#service unsupported-transceiver

Warning: When Cisco determines that a fault or defect can be traced to the use of third-party transceivers installed by a customer or reseller, then, at Cisco's discretion, Cisco may withhold support under warranty or
a Cisco support program. In the course of providing support for a Cisco networking product Cisco may require that the end user install Cisco transceivers if Cisco determines that removing third-party parts will assist Cisco in diagnosing the cause of a support issue.

1 comment:

  1. Thank you for the share this information. This is very useful information for cisco telecom equipment.Keep it up such a nice posting like this.

    ReplyDelete